Difference between revisions of "MCP4912"
From ArmadeusWiki
(→Set channel values) |
(→Use it) |
||
| Line 56: | Line 56: | ||
</pre> | </pre> | ||
| + | === Synchronize channels update === | ||
To have both channels output updated simultaneously (value 2V) when setting the DAC B channel : | To have both channels output updated simultaneously (value 2V) when setting the DAC B channel : | ||
<pre class="apf"> | <pre class="apf"> | ||
Revision as of 14:54, 11 March 2013
Contents
Description
This 2 channels 10bits SPI DAC (Digital to Analog Converter) is mounted on the APF51Dev development boards.
Connections
On your APF51Dev there are 2 signals to use:
- DAC_OUTA: corresponds to OUTA (pin 1 of J5 on the APF51Dev). It's the first output.
- DAC_OUTB: corresponds to OUTB (pin 3 of J5 on the APF51Dev). It's the 2nd output.
The default output voltage range is [0-2.5V] on the APF51Dev (because the 2,5V reference output of the AS1531 is used as reference input for the MCP4912).
Driver
The driver is included in the ARMadeus distribution, and has to be selected (done by default on APF51):
[ ] $ make linux26-menuconfig
Device Drivers --->
<*> Staging drivers --->
<*> Industrial I/O support --->
<M> Microchip MCP4902, MCP4912, MCP4922 driver
Then compile the distribution :
[ ] $ make linux26 && make
Use it
Load driver
To use the DAC first load module:
# modprobe mcp49x2
Set channel values
# cd /sys/bus/spi/devices/spi0.1/device0 # ls dac_power_mode_0 dac_trigger_1 power dac_power_mode_1 out0_raw subsystem dac_trigger_0 out1_raw uevent
To set the DAC A channel value to 2.48V (max range) :
# echo 1023 > out0_raw
To set the DAC B channel value to 1V :
# echo 412 > out1_raw
Synchronize channels update
To have both channels output updated simultaneously (value 2V) when setting the DAC B channel :
# echo 0 > dac_trigger_0 # echo 1 > dac_trigger_1 # echo 825 > out0_raw # echo 825 > out1_raw
