Difference between revisions of "Opos6ul sp fpga simple howto"
From ArmadeusWiki
| (5 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
[[Category: OPOS6UL_SP]] | [[Category: OPOS6UL_SP]] | ||
[[Category: FPGA]] | [[Category: FPGA]] | ||
| − | + | [[Category: Verilog]] | |
| + | {{Under_Construction}} | ||
= Introduction = | = Introduction = | ||
| Line 8: | Line 9: | ||
= Architecture = | = Architecture = | ||
| − | = Software tools = | + | [[File:opos6ul_sp_fpga_tuto_01.png|center]] |
| + | |||
| + | In this tutorial, a simple FPGA design will be done. The objective is to instanciate a block of RAM in the FPGA and be able to read and write data in it from U-Boot then Linux. | ||
| + | |||
| + | = Software tools = | ||
| + | |||
| + | A recent Armadeus BSP is required. | ||
| + | <pre class="host"> | ||
| + | $ git clone git://git.code.sf.net/p/armadeus/code op6sp | ||
| + | $ cd op6sp | ||
| + | $ make | ||
| + | $ make opos6ulsp_defconfig | ||
| + | $ make | ||
| + | </pre> | ||
= Hardware description = | = Hardware description = | ||
Latest revision as of 10:32, 22 July 2020
Page under construction...
Informations on this page are not guaranteed !!
Introduction
This page is a step-by-step tutorial to explain how to develop with FPGA (spartan6) on OPOS6UL_SP Armadeus board.
Architecture
In this tutorial, a simple FPGA design will be done. The objective is to instanciate a block of RAM in the FPGA and be able to read and write data in it from U-Boot then Linux.
Software tools
A recent Armadeus BSP is required.
$ git clone git://git.code.sf.net/p/armadeus/code op6sp $ cd op6sp $ make $ make opos6ulsp_defconfig $ make
