Difference between revisions of "Setup"
From ArmadeusWiki
(→First StartUp) |
(→Packages and Modules) |
||
| Line 18: | Line 18: | ||
* [[FrameBuffer]]: how to configure and use the framebuffer for new LCDs | * [[FrameBuffer]]: how to configure and use the framebuffer for new LCDs | ||
* [[GPIO Driver]]: how to configure the GPIO driver | * [[GPIO Driver]]: how to configure the GPIO driver | ||
| − | * [[Network Configuration]]: how to configure Host and Target network | + | * [[Network Configuration]]: how to configure Host and Target network (NFS, TFTP) |
* [[Serial Transfer]]: transfer files between your Host and your Armadeus board with the RS232 link | * [[Serial Transfer]]: transfer files between your Host and your Armadeus board with the RS232 link | ||
* [[USB Gadget]] -- Instructions to configure your Armadeus board to use it as a USB device (aka Gadget in Linux language) | * [[USB Gadget]] -- Instructions to configure your Armadeus board to use it as a USB device (aka Gadget in Linux language) | ||
Revision as of 19:21, 11 November 2006
On this page, you will find all the usefull informations you need to configure your Armadeus board for optimum usage.
Contents
[hide]First StartUp
Just got your Armadeus board and want to start play with it ? Then follow this quick list to setup your envt accordingly:
- 1.Connect your APF to your development board or to a Devlight --->>
- 2.Connect the Host (your PC) to your development system with a crossover RS232 cable
- 3.Power up the system (+5Vdc for a Devlight )
- 4.Establish the communication between your Host and your APF: See Communicate
- 5.Verify your APF by starting Linux: In uBoot, type "boot". Several informations will be displayed on your console like on the screenshot Linux start screenshot
- 6.If Linux has successfully started, you can proceed with the toolchain installation. See Basics below
Basics
- Toolchain: How to install the development environment for the Armadeus boards
- Communicate: How to communicate with the Armadeus boards from the Host
- Target Software Installation: How to install, uBoot, Linux and your RootFS on the Armadeus boards
Packages and Modules
- FrameBuffer: how to configure and use the framebuffer for new LCDs
- GPIO Driver: how to configure the GPIO driver
- Network Configuration: how to configure Host and Target network (NFS, TFTP)
- Serial Transfer: transfer files between your Host and your Armadeus board with the RS232 link
- USB Gadget -- Instructions to configure your Armadeus board to use it as a USB device (aka Gadget in Linux language)
- MultiMediaCard -- Instructions to use MMC/SD cards with your Armadeus board
- Digital to Analog Convertion: how to configure and use the DAC on your board
Advanced
- BootLoader: (U-Boot useful tips)
- BootStrap: communicate and test your board when no software is installed on it
