Difference between revisions of "SP VISION"
(New page: == Introduction == The board sp_vision is an extension of apf27-Dev and apf51-dev with a spartan6 and two ddr. It is design for video processing. == Configure the Spartan6 with apf27-Dev...) |
|||
| Line 1: | Line 1: | ||
| + | {{Under_Construction}} | ||
== Introduction == | == Introduction == | ||
Revision as of 15:15, 7 January 2011
Page under construction...
Informations on this page are not guaranteed !!
Introduction
The board sp_vision is an extension of apf27-Dev and apf51-dev with a spartan6 and two ddr. It is design for video processing.
Configure the Spartan6 with apf27-Dev
Spartan6 selectmap configuration port is plugged on generic IO of apf27 spartan3 fpga. Then, to configure spartan6, a specific virtual component is required under spartan3. This virtual component is available under POD components library and is named spartan_selectmap. This component must be added to your spartan3 design to enable sp_vision spartan6 configuration.
A simple spartan3 design is available under ARMadeus project tree firmware/sp_vision_config/ to simplify sp_vision config. The design can be synthetized with ISE using the TCL script firmware/sp_vision_config/synthesis/testconfig.tcl. The already synthetized bitstream is also available under firmware/sp_vision_config/bitstream/.
Then to configure spartan6 :
- first configure apf27-spartan3:
BIOS> tftpboot ${loadaddr} top_testconfig.bit
BIOS> fpga load 0 ${loadaddr} 2486f
- then configure the second fpga using loadsecond operator:
BIOS> tftpboot ${loadaddr} spartan6_example_top.bit
BIOS> fpga loadsecond 1 ${loadaddr} 16a674 D6000000 1
