Difference between revisions of "I.MX6 Framebuffer Overlay"
From ArmadeusWiki
m (→Instructions) |
(→Instructions) |
||
| (One intermediate revision by the same user not shown) | |||
| Line 6: | Line 6: | ||
=Tools= | =Tools= | ||
| − | * you will need to compile | + | * you will need to compile following tools: |
| + | <pre class="host"> | ||
| + | $ cd target/demos/fb_alpha | ||
| + | $ ../../../buildroot/output/host/usr/bin/arm-linux-gnueabihf-gcc -o fb_alpha fb_alpha.c | ||
| + | </pre> | ||
| + | * install ''fb_alpha'' on your board's rootfs | ||
=Instructions= | =Instructions= | ||
| Line 26: | Line 31: | ||
** here we move overlay to (200,200):<pre class="apf"># ./fb_alpha -x 200 -y 200</pre> | ** here we move overlay to (200,200):<pre class="apf"># ./fb_alpha -x 200 -y 200</pre> | ||
** same but with no transparency: <pre class="apf"># ./fb_alpha -x 200 -y 200 -g 1 -a 255</pre> | ** same but with no transparency: <pre class="apf"># ./fb_alpha -x 200 -y 200 -g 1 -a 255</pre> | ||
| + | ** same with alpha color/key set to GREEN: <pre class="apf"># ./fb_alpha -x 200 -y 200 -g 1 -a 255 -k 0x00FF00</pre> | ||
[[Category:Framebuffer]] | [[Category:Framebuffer]] | ||
Latest revision as of 14:07, 20 April 2017
Page under construction...
Informations on this page are not guaranteed !!
i.MX6 offers hardware composition of 2 framebuffers for video output. Here are the instructions on how to use it.
 |
Note: These instructions are only available on APF6 with 3.14 Freescale kernel (apf6legacy_defconfig) |
Tools
- you will need to compile following tools:
$ cd target/demos/fb_alpha $ ../../../buildroot/output/host/usr/bin/arm-linux-gnueabihf-gcc -o fb_alpha fb_alpha.c
- install fb_alpha on your board's rootfs
Instructions
- Display something on main Framebuffer (/dev/fb0), here the stream from an analog camera:
# modprobe adv7280_tvin # modprobe mxc_v4l2_capture # gst-launch-1.0 imxv4l2videosrc ! imxg2dvideosink &
- Then activate auxiliary Framebuffer (/dev/fb1):
# echo 0 > /sys/class/graphics/fb1/blank
- and put it some stuff on it:
# fb-test -f 1 &
- then you can set alpha/overlay parameters with fb_alpha tool:
- here we move overlay to (200,200):
# ./fb_alpha -x 200 -y 200
- same but with no transparency:
# ./fb_alpha -x 200 -y 200 -g 1 -a 255
- same with alpha color/key set to GREEN:
# ./fb_alpha -x 200 -y 200 -g 1 -a 255 -k 0x00FF00
- here we move overlay to (200,200):
