Difference between revisions of "Vivado installation on Linux"
From ArmadeusWiki
m (→Launch Vivado) |
(→Introduction) |
||
| Line 4: | Line 4: | ||
== Introduction == | == Introduction == | ||
| − | Vivado is the new | + | Vivado is the new FPGA design tool from Xilinx. It replaces ISE and XPS tools for new product. By default, no Armadeus board has some new Xilinx FPGA that could be targeted by Vivado. But with the new APF6 we can use Artix7 with PCIe on a daughter board (or with Xilinx dev-kit and APF6Dev PCIe connector) and enjoy the new Xilinx-tool. |
This page is a tutorial to install Vivado on debian-linux host computer. | This page is a tutorial to install Vivado on debian-linux host computer. | ||
| − | {{Note| Vivado can't be used with spartan products, it | + | {{Note| Vivado can't be used with spartan products, it starts with "7" FPGA serie (artix7, virtex7, zynq, kintex7, ...)}} |
== Installation == | == Installation == | ||
Revision as of 14:29, 17 March 2015
Contents
Introduction
Vivado is the new FPGA design tool from Xilinx. It replaces ISE and XPS tools for new product. By default, no Armadeus board has some new Xilinx FPGA that could be targeted by Vivado. But with the new APF6 we can use Artix7 with PCIe on a daughter board (or with Xilinx dev-kit and APF6Dev PCIe connector) and enjoy the new Xilinx-tool. This page is a tutorial to install Vivado on debian-linux host computer.
 |
Note: Vivado can't be used with spartan products, it starts with "7" FPGA serie (artix7, virtex7, zynq, kintex7, ...) |
Installation
Requirements
- unsure that Bash is the default shell:
$ sudo dpkg-reconfigure dash
Download
- Download the file on xilinx website, note that you will need an account (free) to do that.
Xilinx_Vivado_SDK_2014.4_1119_1_Lin64.bin
Launch install
- To launch install simply type :
$ chmod 777 Xilinx_Vivado_SDK_2014.4_1119_1_Lin64.bin $ ./Xilinx_Vivado_SDK_2014.4_1119_1_Lin64.bin
- Fill forms then wait for about 20 minutes
Launching Vivado
- Go to the installed directory:
$ cd /opt/Xilinx/Vivado/2014.4
- Source the architecture shell file:
/opt/Xilinx/Vivado/2014.4$ source settings64.sh
- Then launch it:
/opt/Xilinx/Vivado/2014.4$ ./bin/vivado
