Difference between revisions of "Camera interface"
From ArmadeusWiki
m (→Hardware) |
(move driver installation) |
||
| Line 10: | Line 10: | ||
==Driver== | ==Driver== | ||
| − | * CSI interface can be driven through the V4L2 (Video For Linux) standard interface | + | * CSI interface can be driven through the V4L2 (Video For Linux) standard interface as soon as CSI driver is loaded: |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
<pre class="apf"> | <pre class="apf"> | ||
# modprobe mx27_camera | # modprobe mx27_camera | ||
</pre> | </pre> | ||
Revision as of 10:55, 10 June 2009
Page under construction...
Informations on this page are not guaranteed !!
On this page you will find useful informations on how to use the Camera/CMOS Sensor Interface (CSI) of the i.MX chip found on your APF board. Currently only the i.MX27/APF27 are supported.
Hardware
- All the signals of the i.MX27 CSI interface can be found on the J9 connector of the APF27Dev development board.
- You should connect an external camera compatible with the CSI interface (8bits data) to see something ;-). Here are the tested sensor models:
Driver
- CSI interface can be driven through the V4L2 (Video For Linux) standard interface as soon as CSI driver is loaded:
# modprobe mx27_camera
