Difference between revisions of "GSM/GPRS"
From ArmadeusWiki
m (→Linux configuration) |
(→Usage) |
||
| Line 31: | Line 31: | ||
===Configure serial port=== | ===Configure serial port=== | ||
<pre class="apf"> | <pre class="apf"> | ||
| − | # stty -F /dev/ | + | # stty -F /dev/ttySMX1 raw -echo -echoe -echok |
</pre> | </pre> | ||
| Line 37: | Line 37: | ||
* Sending AT commands with ''cu'' utility (be sure to [[cu/uucp|have installed it before]]): | * Sending AT commands with ''cu'' utility (be sure to [[cu/uucp|have installed it before]]): | ||
<pre class="apf"> | <pre class="apf"> | ||
| − | # cu -l /dev/ | + | # cu -l /dev/ttySMX1 |
| + | </pre> | ||
| + | |||
| + | * Check module presence | ||
| + | <pre class="apf"> | ||
| + | ATI3 | ||
| + | SAGEM HiC,A.005.00 | ||
| + | |||
| + | OK | ||
| + | </pre> | ||
| + | |||
| + | * Enter PIN code | ||
| + | <pre class="apf"> | ||
| + | AT+CPIN="1234" | ||
| + | |||
| + | OK | ||
| + | </pre> | ||
| + | |||
| + | * Dial "123456789" | ||
| + | <pre class="apf"> | ||
| + | ATD"123456789" | ||
</pre> | </pre> | ||
Revision as of 17:35, 30 December 2009
Page under construction...
Informations on this page are not guaranteed !!
This page will summarize informations to use the GSM/GPRS module of the APF27Wireless board.
Contents
Introduction
GSM/GPRS are generally driven through the RS232 bus. AT commands are used to dialog with the module. GSM MODEM of the APF27Wireless extension board (APW) is connected to the UART5 (/dev/ttySMX4) of the APF27 module.
Linux configuration
- Linux will have to be configured in order to tell it that an APW is connected to your APF27Dev:
$ make linux26-menuconfig
System Type --->
Freescale MXC Implementations --->
...
Extension board (Wireless (APW)) --->
[*] GSM/GPRS Modem (NEW)
[ ] Bluetooth & WiFi module (NEW)
[ ] CSI (Camera) pass-through (NEW)
[ ] GPS module (NEW)
$ make linux26
- reflash you Linux kernel
Usage
Configure serial port
# stty -F /dev/ttySMX1 raw -echo -echoe -echok
AT commands
- Sending AT commands with cu utility (be sure to have installed it before):
# cu -l /dev/ttySMX1
- Check module presence
ATI3 SAGEM HiC,A.005.00 OK
- Enter PIN code
AT+CPIN="1234" OK
- Dial "123456789"
ATD"123456789"
Tools to look at
- http://www.gnokii.org/
- http://www.alamin.org/en/index.html
- http://www.gammu.org/wiki/index.php?title=Gammu:Main_Page
- http://gatling.ikk.sztaki.hu/~kissg/gsm/index.html
