Difference between revisions of "Bluetooth"
From ArmadeusWiki
(→Links) |
|||
| Line 3: | Line 3: | ||
This page will give you all the informations needed to have a running Bluetooth configuration on your Armadeus board. | This page will give you all the informations needed to have a running Bluetooth configuration on your Armadeus board. | ||
| + | ==Hardware== | ||
| + | First you have to get a compatible hardware. Currently there are 3 solutions: | ||
| + | * Get a [[Wireless extension board]] from armadeus systems (only available for [[APF27]]) | ||
| + | * Get a cheap USB<->Bluetooth adapter (requires an USB Host port) | ||
| + | * Get a RS232<->Bluetooth adapter | ||
| + | |||
| + | ===Tested hardware=== | ||
| + | * TBDL | ||
| + | |||
| + | ==Software== | ||
Bluetooth Linux stack is divided into several parts: | Bluetooth Linux stack is divided into several parts: | ||
| − | * drivers | + | * kernel drivers |
* userland libraries/daemon (bluez) | * userland libraries/daemon (bluez) | ||
Revision as of 15:22, 22 February 2010
Page under construction...
Informations on this page are not guaranteed !!
This page will give you all the informations needed to have a running Bluetooth configuration on your Armadeus board.
Contents
Hardware
First you have to get a compatible hardware. Currently there are 3 solutions:
- Get a Wireless extension board from armadeus systems (only available for APF27)
- Get a cheap USB<->Bluetooth adapter (requires an USB Host port)
- Get a RS232<->Bluetooth adapter
Tested hardware
- TBDL
Software
Bluetooth Linux stack is divided into several parts:
- kernel drivers
- userland libraries/daemon (bluez)
Driver installation
$ make linux26-menuconfig
[*] Networking support --->
<M> Bluetooth subsystem support --->
--- Bluetooth subsystem support
<M> L2CAP protocol support
<M> SCO links support
<M> RFCOMM protocol support
[*] RFCOMM TTY support
<M> BNEP protocol support
[ ] Multicast filter support (NEW)
[ ] Protocol filter support (NEW)
<M> HIDP protocol support
Bluetooth device drivers --->
<M> HCI USB driver
< > HCI SDIO driver (NEW)
<M> HCI UART driver
[*] UART (H4) protocol support
[*] BCSP protocol support
[ ] HCILL protocol support (NEW)
< > HCI BCM203x USB driver (NEW)
< > HCI BPA10x USB driver (NEW)
< > HCI BlueFRITZ! USB driver (NEW)
< > HCI VHCI (Virtual HCI device) driver (NEW)
$ make
Bluez installation
$ make menuconfig
$ make
