Difference between revisions of "Camera interface"
From ArmadeusWiki
(→Hardware) |
(→Driver) |
||
| Line 18: | Line 18: | ||
==Driver== | ==Driver== | ||
* From now we consider that you have a supported camera module plugged on you development board | * From now we consider that you have a supported camera module plugged on you development board | ||
| − | * CSI interface can be driven through the V4L2 (Video For Linux) standard interface as soon as CSI driver is loaded: | + | * CSI interface can be driven through the V4L2 (Video For Linux) standard interface as soon as CSI driver is loaded: |
| + | {| | ||
| + | ! APF27 !! APF6 | ||
| + | || | ||
<pre class="apf"> | <pre class="apf"> | ||
| − | + | # modprobe mx27_camera | |
</pre> | </pre> | ||
| + | | | ||
| + | <pre class="apf"> | ||
| + | # modprobe ov5640-mipi | ||
| + | </pre> | ||
| + | |} | ||
* Then you have to load your camera driver in order for him to "attach" to the CSI one (for example for the OV9653): | * Then you have to load your camera driver in order for him to "attach" to the CSI one (for example for the OV9653): | ||
<pre class="apf"> | <pre class="apf"> | ||
Revision as of 16:25, 14 July 2015
Page under construction...
Informations on this page are not guaranteed !!
On this page you will find useful informations on how to use the Camera/CMOS Sensor Interface (CSI) of the i.MX chip found on your APF board. Currently only the APF27 & APF6 are supported.
Hardware
APF27
- All the signals of the i.MX27 CSI interface can be found on the J9 connector of the APF27Dev development board.
- You should connect an external camera/sensor compatible with the CSI interface (8bits data bus) to see something ;-). Here are the tested sensor models:
- All these sensors are controllable through an I2C interface. The one on J8 connector of APF27Dev can for example be used.
APF6
- APF6Dev boards have a wandcam compatible connector (near the PCIexpress one).
Driver
- From now we consider that you have a supported camera module plugged on you development board
- CSI interface can be driven through the V4L2 (Video For Linux) standard interface as soon as CSI driver is loaded:
| APF27 | APF6 |
# modprobe mx27_camera |
# modprobe ov5640-mipi |
|---|
- Then you have to load your camera driver in order for him to "attach" to the CSI one (for example for the OV9653):
# modprobe ov96xx
- Now it's up to you to configure your camera with the tools/API the camera driver is offering...
Test
- We have a small SDL/V4L2 app to quickly test that your camera is working properly: target/demos/camera/capture/
