Difference between revisions of "USB to Ethernet adapter"

From ArmadeusWiki
Jump to: navigation, search
(LAN JP208)
(Tested hardware)
Line 10: Line 10:
  
 
[[File:lan_jp208.jpg]]
 
[[File:lan_jp208.jpg]]
 +
 +
<pre class=host>
 +
$ make linux-menuconfig
 +
</pre>
 +
 +
<pre class="config">
 +
Device Drivers  --->
 +
    [*] Network device support  --->
 +
        USB Network Adapters  --->
 +
            [...]
 +
            <*>  Multi-purpose USB Networking Framework
 +
            <*>    ASIX AX88xxx Based USB 2.0 Ethernet Adapters
 +
            [...]
 +
 +
</pre>
 +
  
 
=== SMSC LAN9500 ===
 
=== SMSC LAN9500 ===

Revision as of 07:51, 30 April 2020

How-to use USB to Ethernet adapters

Prerequesities

Tested hardware

LAN JP208

Warning Warning: Section not yet finished, tests in progress...

LAN JP208 is a noname USB2 to Ethernet controller adapter.

Lan jp208.jpg

$ make linux-menuconfig
 Device Drivers  --->
    [*] Network device support  --->
        USB Network Adapters  --->
            [...]
            <*>   Multi-purpose USB Networking Framework
            <*>     ASIX AX88xxx Based USB 2.0 Ethernet Adapters
            [...]


SMSC LAN9500

The SMSC LAN9500 is a Hi-Speed USB 2.0 to 10/100 Ethernet Controller. The datasheet can be found here: http://www.smsc.com/media/Downloads_Public/Data_Sheets/9500.pdf. An external EEPROM is used to store the LAN9500 configuration.


Kernel configuration

$ make linux-menuconfig
 Device Drivers  --->
    [*] Network device support  --->
        USB Network Adapters  --->
            [...]
            <M> Multi-purpose USB Networking Framework
            [...]
            <M> CDC Ethernet support
            [...]
            <M> SMSC LAN95XX based USB 2.0 10/100 ethernet devices

Additional tools

In order to read/write the configuration eeprom of the LAN9500, Ethtool has to be used.

$ make menuconfig
Target packages  --->
    Networking applications  --->
            [*] ethtool
            [*]   enable pretty printing
             

Usage

First mount the module:

# modprobe smsc95xx

then start the new ethernet port

# ifconfig usb0 192.168.10.208 up

If the message "No EEPROM present" is displayed, this indicates that no configuration file has been detected in the EEPROM. The LAN9500 will start in a default mode and the MAC address will be randomly generated by Linux. The EEPROM can be read/write by using ethtool once the module loaded

 ethtool -e usb0   # (eeprom read)
 ethtool -E usb0 magic 0x9500 offset xxx value xxx  # (eeprom write value at offset)

Additional informations concerning the EEPROM containt can be found on the SMSC web site.