Difference between revisions of "TSC2102"
VeroniqueL (Talk | contribs) m |
m |
||
| Line 85: | Line 85: | ||
[[Category:UserInput]] | [[Category:UserInput]] | ||
| + | [[Category:Touchscreen]] | ||
[[Category:Audio]] | [[Category:Audio]] | ||
Revision as of 13:39, 9 November 2009
Informations about the hardware interface between the i.MXL and the TSC2102.
Contents
Introduction
This chip is a "SMART" 4-Wire Touch Screen Controller with Stereo DAC and HP Amplifier. It is used on the DevFull board but any good electronics engineer should be able to add it to its DevLight. It is although possible to solder this chip directly on your LQ043 adapter board, if you have one.
Hardware interface with the i.MXL
Touchscreen
Configuration and data exchange is done through the SPI bus n°2 (SPI2).
The SPI 2 port is shared with the LCD interface of the i.MXL (these signals are present on the DevLight V2 LCD connector).
Audio
Configuration is done through SPI2 bus and audio data exchange through SSIA
Signals
| i.MXL/DevLight | TSC2102 | Functionality |
|---|---|---|
| SPI2_SCLK/REV | SCLK | SPI clock |
| SPI2_TXD/SPL_SPR | MOSI | SPI MasterOut SlaveIn |
| SPI2_RXD_1/PS | MISO | SPI MasterIn SlaveOut |
| PortB 17/SSI1_TXDAT | SSn | SPI Chip select |
| SPI2_SS/PortD 8/CLS | PINT/DAVn | Interrupt |
| Reset (on Reset switch) | RESETn | Global reset signal |
Remark:
- i.MXL/DevLight SPI Chip Select signals are not used by Linux SPI infrastructure; it needs multiple chip select (one for each chip connected on the bus), and so GPIOs are used for that purpose.
- Chip interrupt is on Port D because Port B has already some and interrupt are shared on the same port.
Drivers
Self-made adapter board
For those who would like to test this component on their DevLight or their custom boards, take a look at this link: http://www.farnell.fr and type '1426186' as part to search.
This is a small pcb converting a tssop32 to 2 rows of 2.54mm holes...
SSI test tool
Use a special release of tsc2102 driver and imxssi for audio development purpose. Available under buildroot menuconfig->hardware-handling
- Requirements:
TSC2102 mclk: 16MHZ
FS rate: 32KHz
- U-Boot: Enable register debug from U-Boot:
BIOS> run unlock_regs
- Linux: Load tsc driver
modprobe tsc2102
- imxssi: generate ssi signal
Special release of imxssi can generate an audio signal.
just use imxssi with three parameters:
# imxregs param1 param2 param3 param1 can be 0: triangular signal or 1: sinusoïdal signal. param2: period of the signal in number of samples per channel. param3: Signal level coefficient [0.0 .. 1.0].
For example to produce a 300Hz 5v(pk-pk) sinusoid:
# imxssi 1 50 0.15
- next step: dma transfer
Links
| Other languages: | |
|---|---|
|
| |
