Difference between revisions of "Chimei LW700"
From ArmadeusWiki
(→(1) Flat cable) |
|||
| Line 13: | Line 13: | ||
| '''TFT usage''' || flat cable (1) connected between J10 of the APF27Dev and X5 of the LCD_Adapt [[Image:LW700AT_Adapt_to_APF27Dev.jpg|thumb|Connection between APF27Dev and LW700_Adapt]] | | '''TFT usage''' || flat cable (1) connected between J10 of the APF27Dev and X5 of the LCD_Adapt [[Image:LW700AT_Adapt_to_APF27Dev.jpg|thumb|Connection between APF27Dev and LW700_Adapt]] | ||
|---------------- | |---------------- | ||
| − | | '''Touchscreen usage''' || | + | | '''Touchscreen usage''' || All touchscreen signal are provided by main flat cable. |
|- | |- | ||
|} | |} | ||
| Line 23: | Line 23: | ||
'''Do not use long cables.''' | '''Do not use long cables.''' | ||
| − | |||
| − | |||
| − | == | + | == LW700_adapt links == |
* [http://www.armadeus.com/_downloads/lcd_adapt_LQ043 documentation] | * [http://www.armadeus.com/_downloads/lcd_adapt_LQ043 documentation] | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
==Links== | ==Links== | ||
| − | |||
* [[FrameBuffer | Linux framebuffer configuration]] | * [[FrameBuffer | Linux framebuffer configuration]] | ||
* [[SDL_Development | Developing graphical applications with SDL]] | * [[SDL_Development | Developing graphical applications with SDL]] | ||
Revision as of 15:33, 17 December 2009
Page under construction...
Informations on this page are not guaranteed !!
This adaptor board allows you to connect a CHIMEY LW700AT LCD to your DevFull.
The description, the datasheet and the schematics of this adaptor board can be found here.
The following table summarizes the possibilities to connect the LQW700AT and the Touchscreen to your development board:
| APF27Dev | |
|---|---|
| TFT usage | flat cable (1) connected between J10 of the APF27Dev and X5 of the LCD_Adapt |
| Touchscreen usage | All touchscreen signal are provided by main flat cable. |
(1) Flat cable
A simple flat cable (PC like) can be used to connect the LW700_Adapt to the APF27Dev. If you do not have one, a ready to use cable can be found here.
Align the pins 1 (square via) on both boards together.
Do not use long cables.
