Difference between revisions of "GPS"

From ArmadeusWiki
Jump to: navigation, search
m (Troubleshots)
(RS232 modules)
Line 6: Line 6:
 
===RS232 modules===
 
===RS232 modules===
 
The following RS232 receivers were successfully tested:
 
The following RS232 receivers were successfully tested:
 +
* the GPS receiver of the [[Wireless_extension_board|APF27 Wireless extension board]] (uBlox)
 
* the GPS receiver of the [http://projetaurore.assos.univ-fcomte.fr/ Projet Aurore association]. This autonomous receiver uses a standard NMEA GPS module that can be connected to the 3,3V RS232 port of your APF9328. All you need to do is to get the GND and TX signals out of this module and connect is to your GND and RX signals of your APF:<br>
 
* the GPS receiver of the [http://projetaurore.assos.univ-fcomte.fr/ Projet Aurore association]. This autonomous receiver uses a standard NMEA GPS module that can be connected to the 3,3V RS232 port of your APF9328. All you need to do is to get the GND and TX signals out of this module and connect is to your GND and RX signals of your APF:<br>
 
{|border=0 summary="APF pictures"
 
{|border=0 summary="APF pictures"
Line 12: Line 13:
 
|----------------
 
|----------------
 
|}
 
|}
* the GPS receiver of the APF27 Wireless extension board
 
  
 
===USB modules===
 
===USB modules===

Revision as of 14:19, 12 October 2010

This page will summarize informations to connect GPS modules to your Armadeus board.

Introduction

GPS stands for Global Positioning System and is intended to allow one to knows its localization on Earth quite accuratly. See this Wikipedia article for more informations. GPS receivers are generally driven through a low speed RS232 bus or USB.

RS232 modules

The following RS232 receivers were successfully tested:

  • the GPS receiver of the APF27 Wireless extension board (uBlox)
  • the GPS receiver of the Projet Aurore association. This autonomous receiver uses a standard NMEA GPS module that can be connected to the 3,3V RS232 port of your APF9328. All you need to do is to get the GND and TX signals out of this module and connect is to your GND and RX signals of your APF:
Recto
Verso

USB modules

These modules are mostly serial one with a RS232 <-> USB converter. None were tested yet.

Usage

APF27 Wireless (APW)

  • Be sure to have correctly choosen the GPS option while configuring you Linux kernel for the APW. This will autoselect and activate corresponding serial port. Reflash your Linux kernel.
  • Be sure that J3 jumper (near SIM card socket) is plugged in
  • Configure GPS serial port (4 for Linux == UART5 for i.MX) of your APF27 (raw, no echo, 38400 bauds 8N1):
# stty -F /dev/ttySMX4 raw -echo -echoe -echok 38400
  • Test it: you'll get NMEA frames:
 # cat /dev/ttySMX4
 $GPGSV,3,1,12,01,80,354,,02,32,070,38,04,13,037,09,09,14,146,*78
  
 $GPRMC,164916.00,V,,,,,,,130709,,,N*7C
 
 $GPGGA,164916.00,,,,,0,00,99.99,,,,,,*6B

APF9328

  • Configure Serial port 1 of your APF9328 (4800 bauds 8N1):
 # stty -F /dev/ttySMX1 4800
  • Power on your GPS module
  • Test it: you'll get NMEA frames:
 # cat /dev/ttySMX1
 $GPGGA,000026.032,,,,,0,00,,,M,0.0,M,,0000*53
 
 $GPGSA,A,1,,,,,,,,,,,,,,,*1E
 
 $GPRMC,000026.032,V,,,,,,,160406,,*2F
 
 $GPGGA,000027.032,,,,,0,00,,,M,0.0,M,,0000*52

NMEA Frames signification

  • There is a small tool (under development) in target/demos/gps/ that can help you to understand how to parse some NMEA frames in your application.
  • $GPGGA: Global Positioning System Fix Data
  • $GPGLL: Geographic Position, Latitude/Longitude
  • $GPGSA: GPS DOP and Active Satellites
  • $GPGSV: GPS Satellites in View
  • $GPRMB: Recommended Minimum Navigation Information
  • $GPRMC: Recommended Minimum Specific GPS/TRANSIT Data

Troubleshots

  • In case your Aurore GPS module is detected and then automatically removed from the USB stack when you plug it on your PC, try to uninstall brltty:
 $ sudo apt-get remove brltty

Going further

  • If you don't want to manually parse NMEA frames in your app or want to support different GPS receivers type, you'll probably be interested by the GPS daemon

Resources

Links