Beginner's tutorial step 1

• Plug your APFxx module to your development board (custom or DevLight/DevFull) (your system will be hereafter referred to as "the Target")

An APF9328 connected to a DevLight

File:Apf9328 on devfull.png An APF9328 connected to a DevFull

File:Apf27 on dev27.png An APF9328 connected to a Dev27

• Connect your PC (= "the Host") to your board with a null-modem RS232 cable (only Rx/Tx/Gnd signals are needed). If you don't have a RS232 port on your Host, you can use a "USB <-> RS-232" converter (you'll still require the null-modem cable).

File:Rs232cable connected.png

RS232 Null Modem cable connected on the development board

• Connect your Target to your local network with an Ethernet Cable. If you don't any network, you can use an Ethernet crossover cable.

Navigation:
<< Previous step    You are in step N°1    Next step >>