LinuxInstall

From ArmadeusWiki
Revision as of 20:28, 22 September 2006 by Salocin68 (Talk | contribs)

Jump to: navigation, search

How-To install Armadeus Software Development Kit for Linux

Prerequisites for Linux installation

For Debian distrib some additional packages are required. You can use the following command to get the them:

$ apt-get install wget gettext libncurses5-dev subversion autoconf zlib1g-dev

Open a shell and follow this procedure:

Get Armadeus software

If you are a registered developpers, check out the required files from the repository:

$ svn co svn://ericjarrige.homelinux.org/armadeus/trunk armadeus  --username <<YOUR USERNAME>>  --password <<YOUR PASS>>

A directory named armadeus/ will be created on your hard-disk and will contain all the files you need.

If not, then download installation archive from SourceForge: http://sourceforge.net/projects/armadeus and detar it.

Configure Armadeus software

$ cd armadeus/
$ make menuconfig  (or just make the first time).

This will launch buildroot configuration. in Board Support Option menu, select your armadeus board (apf/apm9328), the RAM size (16/32MB) and so on...

  • Exit the configuration tool saving your config

Launch build

$ make

The toolchain is built automatically. During this procedure, several files are downloaded from the web. Please wait for a while.... it takes at least one hour for the first run!

Enjoy the result

The generated binary files can be found in the subdirectory armadeus/software/buildroot:

  • u-boot.brec (can be used with the bootstrap, if U-Boot is not installed or not working, see BootLoader page)
  • u-boot.bin (for download with uboot, see BootLoader "Update u-boot" page)
  • linux-kernel-2.6.xx-arm.bin (for download with uboot, see InstallLinux)
  • rootfs.arm_nfpu.jffs2 (for download with uboot, see InstallFileSystem?)
  • rootfs.arm_nfpu.tar (for an nfsroot, see RootNFS?)

To keep your copy up-to-date within the armadeus tree

$ svn update

This will update your working directory to the latest release.

Note: if "svn update" fails because a directory or a file already exists, then do:

$ rm -rf <this-directory/file>
$ svn update

You can do a:

$ make defconfig

to have the latest features automatically activated and a

$ make menuconfig

to set you again you personnal parameters (SDRAM size...).

You have to do a make to rebuild binary files end then upload the binary files to your target.

Note: if definitively everything goes wrong while it worked before the last update. You can apply the following procedure:

$ rm -rf software/buildroot
$ rm Makefile
$ make
$ make

Enjoy!