PWM
On this page, you will find usefull informations to configure and use the Pulse Width Modulation (PWM) capabilities of your APF9328 board.
The i.MXL processor is capable of driving 2 PWM signals:
- one is linked to the LCD controller and allow to control the LCD backlight
- the other can be used to generate a PWM signal in several mode:
- audio playback
- real PWM
Hardware
i.MXL PWM module is using PWMO (PortA 2) pin as ouput.
- On DevFull development boards this pin is connected to pin 4 (TIM2) of "Timers" connector (X21)
Linux driver installation
i.MXL PWM driver is now installed by default in standard Armadeus rootfs. Following instructions are only given as reference (to uninstall it at rootfs generation for example):
- Launch Linux configuration:
$ make linux26-menuconfig
And in Device Drivers ---> Armadeus specific drivers choose:
- rebuild your system:
$ make
- then, either copy generated module target/linux/modules/pwm/imx-pwm.ko to your system with TFTP or NFS or reflash the generated rootfs. For more informations.
Usage
- Load the module:
# modprobe imx-pwm Initializing PWM class. Initializing PWM#0...PWM major number = 253 PWM driver v0.6 done.
- If you plan to use sound, create /dev/pwm device file if not already existing (Major is dynamically allocated)
# DEV=`cat /proc/devices | grep imx-pwm | cut -d " " -f 1`; mknod /dev/pwm c $DEV 0
PWM Mode
Remark:
- The pwm has a resolution of 1uS
After driver loading, you have access to /sys/class/pwm/... functionnalities:
- to change frequency (for example 500 Hz):
# echo 500 > /sys/class/pwm/pwm0/frequency
- to change period (for example 100us):
# echo 100 > /sys/class/pwm/pwm0/period
- to change duty cycle (for example 50.0%)
# echo 500 > /sys/class/pwm/pwm0/duty
- to activate PWM:
# echo 1 > /sys/class/pwm/pwm0/active
- to de-activate PWM:
# echo 0 > /sys/class/pwm/pwm0/active
Audio Mode
Audio playback mode is working since v0.5 of PWM driver (thanks to User:SebastienR). You can play 8, 16 & 32 KHz 8bit linear RAW sound. It's recommended to play 8kHz one, as they use less CPU ressources. To convert a sound to the right format we recommend to use SoX (on Linux). For exemple:
[host]$ sox /usr/share/sounds/KDE_Chimes_1.ogg -r 8192 -b -u -c 1 Chimes.raw -r -> sampling rate -b -> byte/8bit signal -u -> linear /not compressed -c 1 -> Mono / 1 channel
Then you can test it using target/linux/modules/pwm/test/testplaymode:
[host:/.../armadeus]$ make -C target/linux/modules/pwm/test/ [host:/.../armadeus]$ cp target/linux/modules/pwm/test/testplaymode $NFS_DIR [host:/.../armadeus]$ cp target/linux/modules/pwm/test/KDE_Startup_2.raw $NFS_DIR
on target do:
# testplaymode
or
# testplaymode KDE_Startup_2.raw
