APF51

Description

The APF51 is a high-end Single Board Computer targeted for advanced GUI, intensive computation and extended connectivity.

Here is a list of the main features:

• Processor: Freescale i.MX51 (Cortex-A8 @ 800MHz)
• RAM: Mobile DDR 400. 64 to 512MB. 32 bits data bus. Default capacity will be 256MB.
• Flash: Mobile NAND. 512MB, 8 bits data bus.
• Ethernet: onboard Physical (ready to use Ethernet 10/100Mbit link)
• USB: High speed USB OTG (OnTheGo) with onboard Physical (ready to use USB OTG link)
• USB: 2 High speed Hosts with integrated PHY
• FPGA: Xilinx Spartan 6 (LX9 or LX16). Default: LX9
• Touchscreen controler (4/5 wires)
• Low speed ADCs (up to 4)
• RTC and Watchdog
• Battery charger (Li-On/Li-Po)
• Supplies: high end DC/DC converters and LDOs on board. Only one external supply of 5V required.
• Low power sleep mode
• Mechanical dimensions: ~58x59mm

All the i.MX51 peripherals (LCD, 2xSDIO, 2xSPI, 6xSerial, I2C, CSI, 3xUSB, keypad, PWM, etc...) and the FPGA signals can be accessed through two high density Hirose connectors.

Resources

• Datasheet and schema

Feature list

• APF51_Linux_kernel_status

Video Video Out LCD BackLight FrameBuffer Video In Camera_interface

Wired communication Uart SPI I2C USB_Host USB_Gadget User Input Keypad

Storage MultiMediaCard Other PWM: PWM output J2 pin 18 (2.8V output level if used) GPIO_Driver APF51_PMIC (Touchscreen, RTC, LEDs, GPIOs, ADCs, Battery) FPGA Using_FPGA

Development boards

• APF51Dev
• PPS51