Difference between revisions of "Setup"

Revision as of 20:34, 22 September 2006

On this page, you will find all the usefull informations you need to configure your Armadeus board for optimum usage.

Just got your Armadeus board and want to start play with it ? Then follow this quick list to setup your envt accordingly:
1] Connect your APF to your development board or to a Devlight and power up it (5V)
2] Install the Toolchain
3] Connect your Host with your APF Connect
4] Install your programs on the target Target Software Installation

Basics

• Toolchain: How to install the development environment for the Armadeus boards
• Connect: How to communicate with the Armadeus boards from the Host
• Target Software Installation: How to install, uBoot, Linux and your RootFS on the Armadeus boards

Packages and Modules

• FrameBuffer: how to configure and use the framebuffer for new LCDs
• GPIO Driver: how to configure the GPIO driver
• Network Configuration: how to configure Host and Target network
• Serial Transfer: transfer files between your Host and your Armadeus board with the RS232 link
• USB Gadget -- Instructions to configure your Armadeus board to use it as a USB device (aka Gadget in Linux language)
• MultiMediaCard -- Instructions to use MMC/SD cards with your Armadeus board
• Digital to Analog Convertion: how to configure and use the DAC on your board

Advanced

• BootLoader: (U-Boot useful tips)
• BootStrap: communicate and test your board when no software is installed on it