Beginner's tutorial step 3

We will now power on your board. Check that your power supply is compatible with the following:

Warning: For all development boards: + is in the middle of the connector, - on the side. Use a regulated power supply capable of providing at least 500mA at minimum required voltage.

APF9328

DevLight V1

• Use +5V DC to +9V DC input voltage

DevLight V2

• Use +5V DC to +7V DC input voltage

DevFull

• Use +7V DC to +24V DC input voltage

APF27

DevLight & DevFull

• Use +6V DC to +16V DC input voltage

PPS

• Use +8V DC to +24V DC input voltage
• or USB OTG connector (J3)

APF51

APF51Dev

• Use +8V DC to +28V DC input voltage (standard DC jack input)
• or Li-Po/Li-ion batterie (3.7 or 3.6V) input (J11). Some peripherals will not be powered (please see APF51Dev Datasheet for details)
• or USB OTG connector (J3). In this case some peripherals will not be powered (please see APF51Dev Datasheet for details)

APF28

APF28Dev

• Use +7V DC to +16V DC input voltage (standard DC jack input)
• please see APF28Dev Datasheet for details.

APF6/APF6SP

APF6_Dev

• Use +7V DC to +16V DC input voltage (standard DC jack input)
• please see APF6Dev Datasheet for details.

Links

Build your own battery pack for your APF

Let's go

• Plug your power supply
• You should see some informations displaying in GTKTerm. Wait until the board finished to boot (~10 secs):

Welcome to the Armadeus development environment.
armadeus login:

• if you see nothing then check that you correctly followed the previous steps...

Navigation:
<< Previous step    You are in step N°3    Next step >>

• Full boot messages